![]() So I need to re slice all gcode that I have saved.Īlso the manual bed levelling, which I was doing very successfully, has disappeared. for some reason it homes to back right, but calls front left 0,0,0! and Marlin has switched my Home settings. Octoprint and Marlin 2.0.3 are not playing nicely at the moment. My board didn't have boot loader to start with, which is why I tried with Tiny ISP first (you don't need boot loader!) I didn't have luck with USBTinyISP and have Pi's [ AFAIK, you need something like Arduino/ Pi/ ISP between Mac and printer. I followed the step by step, loading boot loader first, then carried on with Marlin. remember to find and load the Sanguino and U8glib libraries. ![]() I assume you have a raspberry Pi as well (as you're using Octoprint!!).Īrduino IDE works on Mac. Ender 5 (Melzi/ ATMega1284P board) went from Crealitiy's version ?1.6 Marlin to Marlin 2.0.3 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |